VESTAX CLS-1 CUT/LAG SPACER FOR VESTAX CROSSFADERS
A rubber spacer to decrease the "cut-in time" for the cross fader.

The VESTAX CLS-1 will reduce the cut-in time of your Vestax crossfader & eliminate the "Click" heard when the fader normally hits the faceplate. The CLS-1 allows you to cut faster on the cross fader by shortening the fader movement, allowing sound to cut in sharply.

If the crossfader you have is stamped "SFV-03N" then you can use the CLS-1.

The VESTAX CLS1 can only be used with the crossfader of the below-mentioned Vestax DJ mixers if the crossfader you have is stamped "SFV-03N".

PMC-05PRO
PMC-05PRO ll
PMC-06PRO
PMC-06PRO A
PMC-07PRO
PMC-07 ISP
PMC-05PRO lll
PMC-05PRO SL
PMC-007
QFO

CLS-1 can be attached to the CROSSFADER on Vestax products only. It cannot be attached to products that are not listed above or to other company's models. Problems that are caused from other models are the customer's responsibility. Vestax will not be responsible for any misuse or mishandling.

$16.50 FREE SHIPPING IN THE USA!